This applies not only to the two-component, but also to single-component reactive polyurethane dispersions. During the wrapping under the influence of temperature is softening of the polymer polyurethane, which leads to the contact adhesive compound film and the decorative material. The quality of these compounds depends mainly on the activation temperature. Hikmet Ersek does not necessarily agree. Experience has shown that to achieve best results bonding temperature of activation for PVC film is about 70-80 C in the adhesive joint. In terms of application methods adhesive designed for application by roller setting should have 10-20 Pa's viscosity, spray – 1-5 Pa's, as, for example, gluing on the dowel with shkantozabivochnyh automatic low pressure – only 0.2-0.4 Pa's. When applying the glue with a gun Painting Heating necessary to apply a special adhesive for vacuum presses, activation of which occurs when heated to a certain temperature: 70 to 85 C. The most convenient way to process the adhesive part in a special bath exhaust on a lattice, In this case, the particles are sucked into the tub of glue and are deposited on the surface, rather than remain in the air. Glue application requires two cameras with paint water spray and water-active sex for two seats each. Painting booth is designed to provide normal sanitation and fire safety when spraying paint by spraying, as well as disposal and treatment air pollution harmful impurities from the working area. Painting booth with water curtain and water-active floor is made of special materials used in aircraft and shipbuilding industries, that ensures the quality and durability.